FLY AUTOMATION
Automation Industry Expert . Focused on Pneumatic Components 15 years!
Add to Cart
Specification:
Product name: Pneumatic Air Filter Regulator
Condition: New
Fluid: Air
Model: Quick connector style: Japan style
Air Inlet:1/4" BSP Male
Model: Quick connector style: European style
Air Inlet:1/4" NPT Male
Filter+4mm Fitting:For Pipe4*2.5mm
Filter+6mm Fitting:For Pipe6*4mm
Filter+8mm Fitting:For Pipe8*5mm
Filter+10mm Fitting:For Pipe10*6.5mm
Filter+12mm Fitting:For Pipe12*8mm
Max operating pressure: 1.0Mpa(10.2kgf/ cm²)
Ambient & fluid temperature: 5-6°C
Recommended lubrication:Turbine No.1 oil (ISO VG32)
Dimension: 16x16.5cm
Package Includes:
1 x Pneumatic Air Filter Regulator
| Product name: | Pneumatic air filter regulator |
| Condition: | New |
| Fluid | Air |
| Filter Aperture: | 25 μm |
| Cup Material : | Polycarbonate |
| Proof Pressure: | 1.5Mpa(15.3kgf/ cm²) |
| Max Working Pressure : | 1.0Mpa(10.2kgf/ cm²) |
| Ambient & Fluid Temperature: | 5-60°C |
| Recommended Lubrication: | Turbine No.1 oil (ISO VG32) |
| Dimension: | 16x16.5cm |
Features:
*Using standardized modular design, it can be combined and decomposed arbitrarily, the product design is
reasonable, easy to use, and can meet the requirements of various pneumatic systems.
*Transparent inspection hood, you can directly observe the size of dripping oil and water accumulation.
*High-strength resin (polycarbonate) protective cover, safe and reliable to use .
Specifications:
Product name: Pneumatic air filter regulator
Condition: New
Fluid: Air
Filter Aperture: 25 μm
Cup Material : Polycarbonate
Proof Pressure: 1.5Mpa(15.3kgf/ cm²)
Max Working Pressure : 1.0Mpa(10.2kgf/ cm²)
Ambient & Fluid Temperature: 5-60°C
Recommended Lubrication: Turbine No.1 oil (ISO VG32)
Dimension: 16x16.5cm
Install And Use:
The installation of the filter should make the drainage mechanism vertically downward and keep a certain
distance from the ground for drainage and replacement of the filter element. The filter is used to filter solid
impurities and water droplets in the compressed air. It cannot filter out aerosols and water vapor. Therefore,
the filter position should be set after the air dryer, as close as possible to the pneumatic components that
need to be supplied with air. The condensate in the filter bowl should be drained regularly. If manual
operation is inconvenient, you should consider choosing a filter with an automatic release mechanism.
Check the blockage of the filter element regularly. When the pressure drop is greater than 0.05 MPa, it
should be replaced in time. For washable filter elements, you can continue to use them after washing. The
filter bowl should be cleaned with a neutral cleaning agent, and organic solvents are strictly prohibited.